Calibration Garment tape
The tools needed are:
- An iron ruler
- Long table
- Stickers
How to calibration the garment measurement tape: first we put the iron ruler on the table and so after the ruler on the long table we take and put the garment meter above the straight iron
ruler and according to the meter after that we see the number or inch in the
iron ruler we then compare the unit number with the number of units of inches
or centimeters in the meter and we conclude whether the number is the
difference between the iron ruler and the garment meter if not the difference
means that the garment meter is so good if there is the difference means that
the garment meter is not feasible to use because the meter already stretched or shrinkage
See below Picture
Different: 1/4 icnh
Different: 1/4 icnh
After getting the difference or good meter then we make a
note or we write in the record for the document that we have the month and in
what year do we calibrate the garment meter because this document is very
important if there is an audit later
You May Also Like:
- Step by Step Fabric Inspection
- The Top of Garments Visual Devect
- Soft-Lines and Hard-Line Inspection
- Type of Inspection
- Lashes Pre-shipment Inspection
- How to Rattan Chair processing
- How to Rattan Raw Matrial processing
- How to Know sintetic Rattan
- How to on Site Test of Toys
- How to Inspection Toys Electrics
- Toys Test Performed During Inspection
- Quality Control
- Quality Control Procedure
Belum ada Komentar untuk "Calibration Garment tape "
Posting Komentar